This Gerber Guardian II has factory edges and is like new.Good luck bidding!Serial number is A1190T as seen in photos. 'Bob' Loveless, one of the legends of knifemaking.Listing as used because I'm not the original owner and there is wear to the box.

Serial number H9534S on reverse ricasso.- Handle/Hilt/Pommel: Cast aluminum with Camouflage 'Armorhide' coat (electrostatically powder coated)- Sheath material: Camouflage Cordura ballistic nylon- Sheath stone/steel pocket: none- Sheath hanger/clip: BIANCHI® fastenerGerber Guardian knives were designed by the late R.W. a very rare one!- Overall Length: 11 3/4 inches- Blade length: 6 3/4 inches- Blade spine: 1/4 inch at the ricasso- Blade serrations: none- Blade steel: 440C- Blade coating: Non-reflective black coating- Blade etching: none- Tang Stamp: Gerber vertical 'Sword in Stone' logo/GERBER/PORTLAND, ORE. In other words, the knives with the 'T' suffix were only produced upon request and then only for a short time (likely less than 3 years).This Guardian II is one of those knives. For a short time, Gerber honored these special requests and stamped the L6 tool steel versions with an alpha-numeric serial number that ended with a 'T' to distinguish these knives from the stainless steel versions whose serial numbers ended with an 'S'. After this switch was made, some customers made special requests for Mark IIs and Guardian IIs in L6 tool steel rather than 440C.

Serial Number: A1190T.Starting in late 1979/early 1980, Gerber switched from L6 tool steel to 440C stainless steel.

Gerber guardian 2 serial numbers